I am putting a TPI out of a 85 corvette in a 1959 chevy step side.  I am using a 700r4 as a transmission, and i am using a stand alone wire harness.  My problem is that my VSS is electric and I have know were to hook the sensor to.  if anyone has any ideas i would greatly appreciate it  

Go to this URL for swap data you need.

If the 700R4 you have does not have an electic speed sensor than one will need to be installed in the tail housing or as an alternative out in the wind attached to the input shaft of the rear axle.

http://www.jagsthatrun.com/

Bogie