|
Num Posts
Sort Order
|
Greaser
New User
| Posts: 6
| Joined: 03/07
Posted: 04/19/07
10:48 PM
|
|
What's up fellas? I'm thinking of making a couple of big purchaces and would like some feedback.
1.edelbrock performer 27014 manifold
2.edelbrock 600cfm carb.
3.gt3076s dual turbos(14.5 psi)
4.GT Spec XL FMIC intercooler (23x12x3 Inch 3 Inch Inlet & Outlet)
5.(2) Full Stainless Steel Chevy Small Block Turbo exhaust manifold (42mm tubing, 2.9mm wall thickness)
the question is, can i install these parts on my 350 without having to buy new heads or making any other big purchaces?
nothing has been done to the motor as far as i can tell
|
Redbeast1
New User
| Posts: 18
| Joined: 03/07
Posted: 04/21/07
04:18 PM
|
|
How many miles on your 350 block or is it a new engine ?
Which heads are on it now ? make / casting #'s ?
What cam is in it ? piston type ? etc....
Is this going to be a street / strip car or a drive to work to impress friends ride ?
|
Greaser
New User
| Posts: 6
| Joined: 03/07
Posted: 04/23/07
02:51 PM
|
|
I can tell you this much cause i just started tearing down.. the engine has about 50,000-60,000 and has been sitting for bout a year. it will be used for street/strip and the occasional drive to work but it's not my primary car.
|
|
|
RyanS
New User
| Posts: 1
| Joined: 04/07
Posted: 04/28/07
04:48 PM
|
|
I don't think that the Motor will live with 14.5 pounds of boost. I would put a 4-Bolt main block and some Edelbrock Aluminum heads. You might want to think about a bigger carb or even EFI
5-Time PSCA Limited Street Champs
1972 Corvette-377 SBC-AFR Heads- 300HP worth of Nitrous-Turbo 400-Tom's Differential Rear end-Full interior including stereo-3230 pound race weight-28x11.5 Et Streets. Results, 8.98@155.5
|